DAELIM Besbi SC125 Service Manual page 10

SERVICE INFORMATION
In case that the wire harness is contacted with the end or
the sharp edge, protect both parts with tube or tape.
If necessary, lock the wire harness properly.
Do not twist the wire harness.
Prior to using the tester, please read the manual care-
fully and understand the contents.
When testing the resistance of the tester, the zero
adjustment must be performed before testing.
measurement range or
configuration in accord
with the manual?
1-8
Is this
The wire must not hang down or be pulled excessively.
When mounting parts, make sure that the wire harness
is not pressed by the parts.
Wire the wire harness not to be pulled or expanded
when the handle is turned to the right or the left
completely. Avoid excessive bending or chewing and
interference with the engine.
Do not drop or throw the parts especially
semiconductor contained parts because these parts may
be damaged by the impact of the drop.
NOT TO
PULL!