Lights/Meter/Switches; Light Not Turned On When The Main Switch Is On; Dim Headlight; Headlight Hi-Low Bean Cannot Be Charged - DAELIM Besbi SC125 Service Manual

18. LIGHTS/METER/SWITCHES

SERVICE INFORMATION
TROUBLE SHOOTING
HEADLIGHT
FRONT WINKER BULB REPLACEMENT18-2
TAIL LIGHT / REAR WINKER BULB
REPLACEMENT
SERVICE INFORMATION
GENERAL SAFETY
Connect the same color wires together. Connect couplers carrying the same color and the same number of pins together.
All couplers are equipped with tabs which can be locked. Remove these locks prior to disassembling ; and insert these
tabs all the way until locked when assembling.
Carry out continuity test on circuits or parts to diagnose electric systems. The continuity test on normal parts can be
carried out without removing the parts from the vehicle. Simply disconnect the wires and connect a continuity tester or
an ohmmeter to the coupler terminals or connectors.
The continuity test is conducted to check if electric power is connected between 2 terminals. If there is coil resistance
within circuits, or to check the large resistance resulting form the connector corrosion, an ohmmeter is required to check
the circuit resistance value.
TROUBLE SHOOTING

Light not turned on when the main switch is ON

Faulty light bulb
Faulty switch
Faulty or disconnected wiring
Fuse cut
Battery discharged

Dim headlight

Battery discharged
Wiring and switch resistance high

Headlight Hi-Low bean cannot be charged

Faulty light bulb
Faulty dimmer switch
18-1 MAIN SWITCH
18-1 HANDLE BAR SWITCH
18-2 TRUNK LAMP SWITCH
FRONT/REAR STOP SWITCH
FUEL UNIT
18-2
Fuel meter indicator malfunctioning
Coupler separated.
Harness disconnected.
Float operation malfuction.
Fuel unit damaged.
Fuel meter needle unstable
Coupler loose.
Fuel unit damaged.
Meter damaged.
18-3
18-3
18-4
18-4
18-5
18-1