Section 8 Maintenance; Maintenance Schedule - GBC TITAN 110 Operation & Maintenance Manual

Titan 110/ 165 Operation and Maintenance Manual

Section 8 Maintenance

GBC Films Group laminators require minimal
maintenance. However, regular maintenance is essential
to keep any piece of precision machinery at peak
performance. A maintenance schedule and a section of
procedures are included in this section.
Do not wear ties, loose fitting clothes or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
INFORMATION
Improper maintenance, can result in
poor output quality.
GBC offers Cleaning kits ( P/N 1711515 ) as
well as Extended Maintenance Agreements.
The only maintenance required by the operator is
to maintain clean and adhesive free nip rollers and overall
cleanliness of the laminator itself.
© GBC Films Group November 2000
WARNING

8.1 Maintenance Schedule

INFORMATION
Below is a recommended maintenance
schedule. Before performing any of the steps
listed, read through the procedures first.
Please follow the instructions pertaining to
the step you are performing.
Daily
• Clean the rollers
( See cleaning in this section )
• Inspect the electrical cord for damage.
( If damaged, you should replace or repair it
immediately )
Monthly
• Adjust the nip if needed.
( Performed by a qualified Service
Technician )
• Check the chain tension.
( Performed by a qualified Service
Technician )
• Inspect the area around the laminator for
possible hazards
( dust buildup, combustible items
stored too close, etc. )
Maintenance
Page 8 - 1