Change Nip - GBC TITAN 110 Operation & Maintenance Manual

Titan 110/ 165 Operation and Maintenance Manual
5.8 Change the nip
The roller handle raises and lowers the main
rollers and the pull rollers simultaneously. The roller
handle guide is notched with preset nip heights. The
roller handle is located on the right side of the
laminator.
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
Never leave the rollers in the down position
without rolling. Prolonged contact in one
area can form flat spots on the rollers.
a) To change the nip opening, pull the handle
away from the notch and move to the
desired setting and secure the handle in the
appropriate notch.
© GBC Films Group November 2000
WARNING
CAUTION
b) To raise the rollers, follow the steps above in
reverse order.
Operations
Handle in
the raised
position.
Pull handle
away from
the notch.
Lower
handle to
desired
position.
Push handle
into the
notch
Page 5 - 15