Section 5 Operations; Control Panel - GBC TITAN 110 Operation & Maintenance Manual

Titan 110/ 165 Operation and Maintenance Manual

Section 5 Operations

Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
This section discusses the function of the
control panel, how the footswitch operates, how to
react to an emergency, remove and replace the safety
shield, remove and replace the pressure plate, remove
and replace the feed table, how to load film on the
unwinds, how to center the film, how to change the
nip, use the rear cut-off and job programming.
The operations of the Titan 110 do not differ
from the operations of the Titan 165. For illustration
purposes, the Titan 110 is used.
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.
© GBC Films Group November 2000
WARNING

5.1 Control Panel

The control panel on the Titan 110/ 165
Laminator is located at the front operating position of
the machine on the right side cabinet.
The control panel enables the operator to
control motor run/ stop, motor direction, motor speed,
cooling fans, top temperature, bottom temperature,
job number selection, job programming and
temperature reading.
( 1 ) STAND-BY
STAND-BY
laminator in the AUTO-OFF mode ( indicated in the
lower right corner of the display). Pressing
will set the laminator into READY mode. AUTO-OFF
mode will automatically be set when no motor action
occurs within a four (4) hour time span. After three
(3) hours of no motor action, the laminator
automatically drops the heater temperatures to 176
o
( 80 C ).
Operations
: When pressed, sets the
again
STAND-BY
1
Page 5 - 1
o
F