Troubleshooting Chart - GBC TITAN 110 Operation & Maintenance Manual

Troubleshooting

7.2 Troubleshooting chart

Symptom
Motor is not working
Roller has no heat
Waves in output
Output looks cloudy
Page 7 - 4
Titan 110/ 165 Operation and Maintenance Manual
Possible cause
• E-STOP is pressed
• Feed table not installed
correctly
•Safety shield is raised
• Job parameter is set for
no heat
• Cooling fans are off
• Film tension is incorrect
• Insufficient roller
pressure
• incorrect speed
• Temperature is too low
• Insufficient roller
pressure
Possible cause
• Unlatch E-STOP
• Reinstall feed table
• Close the safety shield
• Select new job number or
increase set point
• Turn cooling fans on
• Adjust film tension
• Adjust roller pressure
• Adjust speed
• Increase temperature
• Adjust roller pressure
© GBC Films Group November 2000