Cleaning And Maintenance - GBC FusionPunch II Service Manual

Cleaning and Maintenance

The Punch and Stacker require periodic
cleaning. When you are servicing the
FusionPunch II, perform the following
maintenance procedures:
Every Call
The following maintenance should be
completed during each service call:
1. Clean all Sensors and Reflectors.
2. Use alcohol to clean all Rollers, Belts, and
O-rings.
Subsystem Maintenance
The following maintenance should be
completed when servicing a subsystem:
1. Remove the Covers and inspect all Belts,
Bearings, and Shafts for excessive wear.
2. Remove the Deck Covers. Use a vacuum
to clean the inside of the machine.
3. Clean the Punch Motor and the
Deck Motor.
4. Check that all Motor and Sensor wires and
connections are tight.
Cleaning and Maintenance
12/2003
1-18
GBC FusionPunch II Service Manual