Film Alignment - GBC TITAN 110 Operation & Maintenance Manual

Operations

5.7 Film alignment

When using two rolls of laminate, the two
rolls should be closely aligned to one another. This
prevents exposed adhesive from contacting the
rollers.
a) Make the necessary adjustments to the
upper roll of laminate to center it to the
main rollers.
b) Remove the safety shield by raising the shield
and pulling the positioning pin out located on
the right side from the front.
Page 5 - 14
Titan 110/ 165 Operation and Maintenance Manual
c) Remove the front feed table by pulling the
safety pin located under the feed table on the
left from the front.
d) Pull the laminate from the upper unwind
down to the lower roll of laminate.
e) Make the necessary adjustments to the
lower roll of laminate to match up with the
upper roll of laminate.
© GBC Films Group November 2000