Safety Shield - GBC TITAN 110 Operation & Maintenance Manual

Titan 110/ 165 Operation and Maintenance Manual
d) Reset the E-STOP by rotating 1/4 turn
clockwise. The E-STOP will unlatch.
Rotate 1/4 turn
INFORMATION
The Temperature control panel settings
are not affected when an E-STOP
has been pushed.
e) Ensure that the front safety shield is located
in the fully closed position.
INFORMATION
Power to the motor is removed when
the safety shield is not in the fully
locked position.
© GBC Films Group November 2000

5.3 Safety shield

Caution should always be exercised
when using the laminator with
the safety shields removed.
You can be seriously HURT or INJURED!
At no time should you attempt to over ride
any of the safety latches on the laminator.
INFORMATION
All E-STOPS must be unlatched, safety
shield fully closed and feed table properly
installed before operating.
The only time the safety shield should be
removed is when you are webbing the laminator. At
no time should you operate your laminator with the
safety shield removed.
Operations
WARNING
DANGER
Page 5 - 7