Pre-Installation Check List - GBC TITAN 110 Operation & Maintenance Manual

Titan 110/ 165 Operation and Maintenance Manual
Section 4 Installation
GBC Films Group is committed to a program of
ongoing product improvement. As a result, we are
providing these instructions so that you can insure that
your new Titan 110/ 165 Laminator is properly and securely
unpacked, moved, and installed.
Before a Titan 110/ 165 Laminator can be
installed, there are a few requirements that must be met.
Make certain that each of the requirements listed in the
following pre-installation checklist are met before beginning
installation.
Failure to follow the pre-installation check
list can result in damage to the laminator.
4.1 Pre-installation
Are the doorways and hallways wide enough for
the the laminator to be moved to the installation
site?
Is there ample room for the laminator?
A work area must be established that allows for
unrestricted movement around the laminator and
provides space for efficient material flow. Figure
4.1.4 and Figure 4.1.5 illustrates a typical machine
area layout.
© GBC Films Group November 2000
CAUTION
Is the enviroment appropriate for the laminator?
The laminator requires a clean, dust and vapor
free enviroment to operate properly. It must not
be located where there is air blowing directly on
the machine.
Have you contatced a certified electrician to install
a receptacle for the laminator and ensure that
adequate power is being supplied, having the the
appropriate capacity, over current protection and
safety lockouts are available?
WARNING
The operating environment must be free of
dust, flammable liquids and vapors. You can
be injured by inhaling chemical vapors.
WARNING
Vapor build up or stored flammable liquids
can cause a fire. Excessive dust can damage
the laminator.
CAUTION
Do not locate the laminator where air is
blowing directly on the machine. The air
flow can cool the rollers unevenly and
result in poor quality output.
Installation
Page 4 - 1