Section 7 Troubleshooting; Wave Problems - GBC TITAN 110 Operation & Maintenance Manual

Titan 110/ 165 Operation and Maintenance Manual

Section 7 Troubleshooting

Do not wear ties, loose fitting clothes or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
As an operator, you can perform simple
troubleshooting to correct typical output problems. Use
the following guide for assistance.

7.1 Wave problems

Following is a list of common output wave
problems you may encounter.
The arrow along the length of the web represents
the direction of ( travel ).
INFORMATION
For optimal temperature settings of
various laminates, contact your
supplier or sales representative.
© GBC Films Group November 2000
WARNING
Problem: D waves in the image but not in the laminate
Cause: Excessive roller pressure.
Hints: • Check paper tension
• Check relative moisture content of the paper
Problem: D Waves in the laminate
Cause: Insufficient roller pressure.
Troubleshooting
Page 7 - 1