Table of Contents
Advertisement
6 Settings and Confirmation
•
If [majorAlarm] or [fatal] is displayed, follow
the procedure below to restart the system,
then perform the settings again.
1.
Click [Back] on the Web browser.
2.
Click [restart] under [System Restart] ®
[System restart] on the System Operation
screen.
8.
Click [view] under [Firmware Update] ® [Check
installed firmware version] on the System Operation
screen.
•
Confirm the version of the software you are
using.
9.
Click [Back] on the screen.
•
The System Operation screen is displayed.
10.
Click [Browse...] under [Firmware Update] ®
[Select a file to upload:] on the System Operation
screen, then navigate to the latest firmware.
11.
Click [start] under [Firmware Update] ® [Execute
firmware update] on the System Operation screen.
•
The software update starts. It takes about 12
minutes. When the update is complete, the unit
will automatically restart.
12.
Perform steps 1–8 to confirm that the software has
been updated.
13.
Click [Back] on the screen.
•
The System Operation screen is displayed.
14.
Click [restart] under [System Restart] ® [System
restart] on the System Operation screen.
Note
•
Make sure you do not access any Web sites
while performing settings on the System
Operation screen.
•
Make sure to close the browser after finishing
performing settings.
6.6.2 Updating the Contact List
1.
Perform steps 1–7 in "6.6.1 Updating Software"
(Page 43).
2.
Perform steps 7–11 in "6.5.3 Adding to the Contact
List" (Page 41).
44
Installation Manual
Note
•
Make sure you do not access any Web sites
while performing settings on the System
Operation screen.
•
Make sure to close the browser after finishing
performing settings.
•
Make sure to set the Web port status to closed
after finishing performing settings. For details,
refer to "When setting the Web port status to
closed: (Page 40)".
Advertisement
Table of Contents
