Table of Contents
Advertisement
6 Settings and Confirmation
Setting
Web port status setting
40
Installation Manual
Command
httpenable
Set the permanent status of the Web port to open or
closed. The default setting is "0" (the Web port is
closed).
1.
Log in to the terminal emulator, enter "service
stop", and then press [Enter].
2.
When setting the Web port status to open:
Enter "httpenable set defenable 1", then press
[Enter].
Notice
•
Setting the Web port status to always be
open presents a possible security risk, such
as an increased possibility of unauthorised
access. Please gain permission from the
customer before performing the network
settings.
When setting the Web port status to closed:
Enter "httpenable set defenable 0", then press
[Enter].
3.
Enter "syssave", press [Enter], then turn the power
off and back on to restart the unit.
Note
•
Even if the Web port status is set to closed, it is
possible to open the Web port for 60 minutes by
entering "webport open" then pressing [Enter].
The Web port will close automatically after 60
minutes.
Value
Advertisement
Table of Contents
