Section 8: Installing & Removing The Door - Montigo PL38DF Installation & Maintenance Manual

PL38DF* Indoor Gas Fireplace
Section 8: Installing & Removing the Door
Removing the door:
The PL38DF* doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch
the door buckles and, remove the door. Replace in reverse order.
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.
Step 1: Remove the Horizontal Access Panel:
Remove the Horizontal cover
by placing fingers in both
finger holes, then pushing
away from you and lifting
out. Place it aside during
maintenance or cleaning.
Install in reverse order.
Figure 25. Removing and installing the Horizontal Access Panel
Step 2: Locate the Door Buckles:
Figure 25a. Locate the door buckles.
Hand-hold
Figure 25b. Door buckle Tool
Page 24
Installation
Finger Holes
Door Latch Slot
Door Latch Hook
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under
door frame as shown.
Figure 25c.
Step 5:
Ensure the tool is firmly in
the lower end of the slot
as shown, then pull toward
you (Caution: hold the tool
securely).
Figure 25d.
Step 6:
Pull hard if necessary
to release the spring
tension. (Caution: The
latch springs back with
force, hold the tool
securely).
Figure 25e.
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 25f.
1
2
3
4
XG0216 - 160215.1