Table of Contents
Advertisement
Section 6:Removing & Installing the Interior Face Door
Removing the doors:
The doors are removed in a few simple steps.
Follow the steps below to remove the Vertical Door trim, place the Door removal tool,
and then remove the door. Replace all the parts in reverse order.
Step 1. Remove the two (2) Vertical Trim pieces, (LH & RH). Pulling firmly with
your fingers, remove from the bottom then the top. (See Figures 17 & 17a). Other
side Typical.
Figure 7. (Remove LH Trim) Figure 7a. (Remove RH Trim)
Step 2. Remove the supplied glass lifting tool from the packaging. Place in the
center of the Glass door as shown, and activate the suction feature of the tool,
Figure 17b. NOTE: Read ALL the instruction supplied with the tool, and follow the
associated operating procedures.
Figure 7b. Supplied Glass lifting tools.
XG0775 - 032511
Installation
Step 3. Hold the Glass Removal Tools firmly, Lift the door upward, into the top door
frame, Figure 17c. Then pull the bottom of the glass door downward, and tilt outward
from the bottom fireplace door frame. Figure 17d. NOTE: Read ALL the instruction
supplied with the tool, and follow the associated operating procedures.
Lift Upward into
the door frame.
Figure 7c. (Lift the door upward)
Figure 7e.
Installing the Door:
To install the door, follow Steps 1 and 4 above, (
top edge of the door frame into place. Lower and rest the door frame in place and
fasten the buckles.
Do not use ammonia based or abrasive cleaners on the glass, they will permanently
etch the surface. Use an approved gas fireplace glass cleaner such as Kel-Kem or
White off.
R324-STIO Indoor Outdoor Ventless Gas Fireplace
Lift Downward
& away from frame.
Figure 7d. (Lift the bottom of the
door outward).
Step 4. Still holding the Glass Removal Tool
firmly, remove the door outward, and away
from the Fireplace, Figure 17e.
Step 5. Place the door in a safe location while
maintenance, cleaning or other operation are
in progress.
NOTE: Read ALL the instruction supplied
with the tool, and follow the associated
operating procedures.
Step 6. To replace, See Installing the
Door, Below.
in reverse order
NOTICE
). ........Hook the
Page 11
Advertisement
Table of Contents
