Table of Contents
Advertisement
Section 8: Installing & Removing the Door
Removing the door:
The doors are removed in a few simple steps. Follow these below to
remove the Horizontal access panel, unlatch the door buckles and,
remove the door. Replace in reverse order.
WARNING
When reinstalling the door(s), always make sure all door buckles are
properly hooked and fully engaged.
TOOLS REQUIRED:
Hand-hold
DOOR BUCKLE TOOL
Figure 23. Door buckle Tool
STEP 1:
Remove the Horizontal
valve blind by placing
fingers in both finger holes,
then pushing away from
you and lifting out. Place it
aside during maintenance
or cleaning.
Install in reverse order.
Figure 23.b Removing and installing the Horizontal Access Panel
STEP 2:
Locate door buckles
Door Buckles
Figure 23.c Locate door buckles
STEP 3:
Firmly grasp handhold end
of Door buckle tool and
place the machined end in
the slot under door frame.
(as shown)
Figure 23.d Locate door latches
30
Door Latch Slot
Door Latch Hook
1
STEP 4:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you.
Figure 23.e Pull door latches
STEP 5:
Pull hard if necessary to
release the spring tension.
(Caution: The latch springs
back with force, hold the
tool securely).
Figure 23.f Lift the latch upward
STEP 6:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the
door. (Repeat all 4-steps
for the remaining latches).
Figure 23.g Lift the door up and out of the fireplace frame
STEP 7:
Grasp the Door on either side, usually midway and lift upward,
lift the door carefully up and away from the front of the fireplace.
Place the Door aside in a safe place while maintenance and / or
cleaning is being performed.
Figure 23.h Removing and installing the glass doors.
Reinstalling the door
To install the door, hook the top edge of the door frame into place.
Lower the door into position and follow the previous steps shown in
reverse order.
Installation
2
3
4
XG0223
Advertisement
Table of Contents
