Section 9: Installing The Accessories - Montigo PL38DF Installation & Maintenance Manual

PL38DF* Indoor Gas Fireplace

Section 9: Installing the Accessories

Installing the Firestones
The PL38DF* is supplied with firestones. Remove the
Door as shown in Section 8. Follow these instructions
to ensure all parts are removed or replaced as required.
Once the Trim and glass door is removed place the
firestones in a single layer across the pan and the
burners as described in Figure 26 to 26d.
Note: Only cover the burner with one layer of designer firestones.
Figure 26 Installation of the firestones. (Ensure ONLY one
layer of firestones cover the surface).
Figure 26a. Spreading the firestones evenly and make sure
there are no firestones covering the pilot .
Figure 26b. Completed firestone installation.
Page 26
Installation
Figure 26c. Completed firestone installation. (Note: DO NOT
place ANY firestones on top of the pilot cover).
Figure 26d. Gas fireplace with firestones
If the firestones are not placed properly (ONE LAYER
ONLY), on burners excessive sooting will result. The
firestones will get very hot while the fireplace is in
operation, and should not be handled until cool.
If the pilot cover is covered with firestones it may result
in delayed ignition and/or damage to the appliance and/
or surrounding property.
WARNING: This appliance is intended for use only with
the included Montigo burners and accessories.
Never install or add any additional or alternative media,
rock wool or other material in this appliance.
The use of additional or alternative materials may pose
potential safety hazards, damage to the appliance, and
void manufacturer's warranty.
CAUTION!
WARNING!
XG0216 - 160215.1