Standard Installation Checklist - Montigo PL38DF Installation & Maintenance Manual

Standard Installation Checklist

This standard installation checklist is to be used by the installer in conjunction with, not instead of, the instructions contained within
this installation manual.
Customer
Install Address:
Model (circle one):
PL38DFN
Appliance Install: Section 2
Framing complies with install manual.
Standoffs have been installed.
Proper clearances have been maintained.
Venting: Section 3
Venting configuration complies with vent diagrams.
Venting installed, fastened, and secured in place maintaining
proper clearance.
Firestops installed.
Exterior wall/roof flashing installed and sealed in compliance with
local building code.
Terminations installed and sealed in compliance with local building
code.
Direct vent termination is highest point in vent assembly.
Wiring/Electrical: Section 4
Unswitched power provided to the appliance PPO box.
Low voltage wire connected to dry contact wall switch (non-
powered)
Gas: Section 5
Proper appliance for fuel type.
Was a conversion performed?
Leak check performed & inlet pressure verified.
Finishing: Section 6
Only non-combustible materials installed in non-combustible areas.
Clearances meet installation manual requirements
Mantels and/or projections comply with install manual
Appliance Setup: Section 7 through 9
Media, door, and screen installed according to install manual
Manual given to home owner.
Started apliance and verified no gas leaks exist.
Comments:
XG0216 -160215.1
Installation
PL38DFL
Date Installed:
Location of Fireplace:
Installer:
Dealer Phone:
Serial #:
YES NO
PL38DF* Indoor Gas Fireplace
IF NO, WHY NOT?
Page 5