Section 8: Installing & Removing The Door; Removing The Door; Reinstalling The Door - Montigo H Series Installation & Maintenance Manual

Pier, bay & corner
Table of Contents

Advertisement

Section 8: Installing & Removing the Door
Removing the door
the doors are removed in a few simple steps. Follow these below to
remove the horizontal access panel, unlatch the door buckles and,
remove the door. Replace in reverse order.
WarNiNg
when reinstalling the door(s), always make sure all door buckles are
properly hooked and fully engaged.
TOOLS REqUIRED:
Hand-hold
DOOR BUCKLE TOOL
figure 20.a Door buckle Tool
STEP 1:
Remove the horizontal
valve blind by placing
fingers in both finger holes,
then pushing away from
you and lifting out. Place it
aside during maintenance
or cleaning.
Install in reverse order.
figure 20.b Removing and installing the Horizontal Access Panel
Fixed
STEP 2:
panel
locate door buckles
figure 20.c Locate door buckles
STEP 3:
Firmly grasp handhold end
of door buckle tool and
place the machined end in
the slot under door frame.
(as shown)
figure 20.d Locate door latches
28
Door Latch Slot
Door Latch Hook
door buckles (PRc shown)
Door buckles
1
STEP 4:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), then pull
toward you.
STEP 5:
Pull hard if necessary to
release the spring tension.
(caution: the latch springs
back with force, hold the
tool securely).
STEP 6:
Remove the tool from
the latch slot. ensure the
latches are hanging freely,
the hook end is released
from the bottom of the
door. (Repeat all steps for
the remaining latches).
figure 20.g Lift the door up and out of the fireplace frame
STEP 7:
grasp the door on either side, usually midway and lift upward,
Fixed
lift the door carefully up and away from the front of the fireplace.
panel
Place the door aside in a safe place while maintenance and / or
cleaning is being performed.
figure 20.h Removing and installing the glass doors.

Reinstalling the door

to install the door, hook the top edge of the door frame into place.
lower the door into position and follow the previous steps shown in
reverse order.
Installation
figure 20.e Pull door latches
figure 20.f Lift the latch upward
4
2
3
Fixed
Panel
xg0227 - 112718

Advertisement

Table of Contents
loading

Table of Contents