Troubleshooting; Sit Proflame 2 - Montigo PL38DF Installation & Maintenance Manual

Troubleshooting:

SIT Proflame 2:

The following is a troubleshooting chart of possible problems:
PROBLEM
Pilot Igniter won't spark
Pilot Igniter sparking, but
Pilot burner will not light
Pilot lights , but Main
burner will not Light
Pilot lights , but Main
burner will not Light and
igniter continues to spark
All spare parts, optional fans, and optional trim finishes are available from your local Montigo dealer.
XG0216 -160215.1
Maintenance
SOLUTION
1. Check the MAIN ON-OFF switch
(typically located below the valve
cover) and turn ON
2. Ensure main power is ON or new
batteries are installed in the remote
control and backup battery pack (if
available).
3. Check the 3.15A fuse in the control
box and replace if necessary
1. Verify the Inlet and Manifold Gas
Pressure are within acceptable limits
2. Check all connections to gas valve
3. Check connection to stepper motor
(if available)
1. Check and verify all wiring
connections as per the wiring
diagram.
2 . Verify the inlet and Manifold
Pressure are within acceptable
limits
1. Check the Pilot Flame Sensor
Rod and clean with steel wool
or similar.
2 . Check the Pilot hood and
clean with steel wool if dirty.
3. Adjust pilot flame using the
pilot adjustment screw if the pilot
flame is too long or too short
(Flame should fully engulf the
sensor rod and must be stable).
4. Check and make sure the
ground wire from the pilot is
connected to the fireplace body.
If your fireplace still does not operate correctly, consult your local Montigo dealer.
All service and repairs should be performed by a qualified Technician.
PL38DF* Indoor Gas Fireplace
Page 37