Applying Effects To Audio; Applying Effects To Input Audio - Roland v-1hd Owner's Manual

Audio Operations

Applying Effects to Audio

You can apply effects to audio that is input and output to adjust its sound quality.

Applying Effects to Input Audio

This applies effects and adjusts sound quality for
audio input via AUDIO IN, MIC, and HDMI IN.
The following table shows the effects you can use
with the different input audio streams.
Input audio
EQ DELAY
AUDIO IN

MIC

HDMI IN

1.
Press the [AUDIO] button to display the AUDIO
menu.
2.
Use the [ ] and [ ] buttons to select the effect
menu item you want to use.
* For more information about effects, refer to the following
section.
3.
Use the A/B fader to adjust the setting value.
4.
Press the [AUDIO] button to quit the menu.
Equalizer (EQ)
This adjusts the sound quality for each frequency band.
Menu item Explanation
HDMI IN 1 EQ Hi This boosts or attenuates the high band.
:
This adjusts the center frequency when
EQ Hi
changing the sound quality in the high
HDMI IN 4
FREQ
band.
AUDIO IN
EQ Mid This boosts or attenuates the middle band.
MIC
This adjusts the center frequency when
EQ Mid
changing the sound quality in the
FREQ
middle band.
This adjusts the width of the frequency
EQ Mid
band when boosting or attenuating the
Q
middle band.
EQ Lo This boosts or attenuates the low band.
This adjusts the center frequency when
EQ Lo
changing the sound quality in the low
FREQ
band.
26
Effects
GATE COMP
— —

  
— —

Delay (DELAY)
This outputs audio with a delay.
Delaying audio output lets you align the output
timing of video and audio.
Menu item
HDMI IN 1
HPF
:
—
HDMI IN 4 DELAY
AUDIO IN

MIC
—
Compressor (COMP)
This compresses audio that exceeds a specified level.
Menu item Explanation
MIC COMP
MIC COMP-
THRESHOLD
MIC COMP-
RATIO
MIC COMP-
ATTACK
MIC COMP-
RELEASE
Gate (GATE)
This mutes audio that is below a specified level.
Menu item
MIC GATE
MIC GATE-
THRESHOLD
MIC GATE-
RELEASE
High-pass Filter (HPF)
This cuts off unneeded low-band audio. The cutoff
frequency is 75 Hz.
Menu item
MIC HPF
Explanation
This adjusts the delay time for audio.
This sets the compressor on or off.
This sets the level used as the threshold when
compressing audio. Compression is applied to
audio that exceeds the level set here.
This specifies the degree of compression
applied to the audio. The state in which no
compression is applied is defined as "1. "
This sets the time until compression starts
when audio exceeding the threshold is input.
This adjusts the length of time until
compression ends after audio falls below the
threshold.
Explanation
This sets gate on or off.
This sets the level used as the threshold for
removing audio. Audio below the level set
here is removed.
This adjusts the length of time until the
audio is fully attenuated after audio falls
below the threshold.
Explanation
This sets the high-pass filter on or off.