Audio Operations; Adjusting The Volume Level - Roland v-1hd Owner's Manual

Audio Operations

Adjusting the Volume Level

This adjusts the volume level of input audio and output audio.
MEMO
5 You can output a test tone, which is useful for adjusting
the volume level. Press and hold the [(TAP) BPM] button
g set "TEST TONE OUTPUT" at the SETUP menu to "ON. "
1.
Press the [AUDIO] button to display the AUDIO
menu.
2.
Use the [ ] and [ ] buttons to select the input
audio whose volume level you want to adjust.
You use the following items to adjust the volume
level of input audio.
Menu item Explanation
Input audio from respective HDMI
HDMI IN 1–4 LEVEL
sources
AUDIO IN LEVEL Input audio from AUDIO IN
MIC LEVEL Input audio from MIC
3.
Use the A/B fader to adjust the volume level for
the respective input audio.
Raise the volume level of audio you want to
make more prominent, such as, for example,
a - microphone, and lower the volume level for
other audio.
When no audio is input, and for audio that is
unused, set the volume level to "0" (zero).
MEMO
5 Setting "MASTER OUT LEVEL" to "0" (zero) results in no
audio output from the output connectors.
4.
Use the [ ] and [ ] buttons to select "MASTER
OUT LEVEL."
5.
Use the A/B fader to adjust the volume level of
output audio.
6.
Press the [AUDIO] button to quit the menu.
MEMO
5 When the [AUDIO] button is illuminated, the [A-1]
through [A-4] and [B-1] through [B-3] buttons function
as shortcuts for AUDIO menu selection. You can select
audio whose volume level you want to adjust by pressing
a shortcut button.
5 To adjust MIC input sensitivity, you use the [MIC] knob on
the side panel.
5 The AUDIO indicator above the [AUDIO] knob lights up
as follows according to audio input and output.
Indicator Status
Lighted in This lights up in green when audio input is
green detected.
This lights up in red when the volume level
Lighted in exceeds the maximum input/output level.
red Audio output from the V-1HD might be
distorted in such cases.
* By factory default, the display of the AUDIO indicator is
set to "MASTER OUT" (output audio signal level).
If you want to use the AUDIO indicator to monitor other
audio signal, press and hold the [(TAP) BPM] button g
make the setting using "AUDIO LED" at the SETUP menu.
Button AUDIO menu
[A-1] HDMI IN 1 LEVEL
: :
[A-4] HDMI IN 4 LEVEL
[B-1] AUDIO IN LEVEL
[B-2] MIC LEVEL
[B-3] MASTER OUT LEVEL
25