Applying Effects To Audio; Applying Effects To Input Audio - Roland V-60HD Owner's Manual

Audio Operations

Applying Effects to Audio

You can apply effects and adjust the sound quality.

Applying Effects to Input Audio

This applies effects and adjusts the sound quality for AUDIO IN, SDI IN, and HDMI IN audio.
1.
Select the [MENU] button0"AUDIO INPUT"0the input
audio.
2.
Select an effect menu item, then use the [VALUE] knob to
adjust it.
* For more information about effects, refer to the following
section.
3.
Press the [VALUE] knob to apply the setting.
4.
Press the [MENU] button to quit the menu.
High-pass filter (HPF 75Hz)
This cuts off unneeded low-band audio. The cutoff frequency is 75 Hz.
Menu item Explanation
HPF 75Hz This sets the high-pass filter on or off.
Delay (DELAY)
This outputs audio with a delay.
Delaying audio output lets you align the output timing of video
and audio.
Menu item Explanation
DELAY This adjusts the delay time for input audio.
Gate (GATE)
This mutes audio that is below a specified level.
Menu item Explanation
GATE This sets gate on or off.
This sets the level used as the threshold for removing
THRESHOLD
audio. Audio below the level set here is removed.
This adjusts the length of time until the audio is fully
RELEASE
attenuated after audio falls below the threshold.
26
Compressor (COMP/LMT)
This compresses audio that exceeds a specified level.
Menu item Explanation
COMP/LMT This sets the compressor on or off.
This sets the level used as the threshold at which the
THRESHOLD compressor is applied. Compression is applied to
audio that exceeds the threshold.
This species the degree of compression applied
RATIO
to the audio. The state in which no compression is
applied is defined as "1. "
This sets the time until compression starts when
ATTACK
audio exceeding the threshold is input.
This adjusts the length of time until compression
RELEASE
ends after audio falls below the threshold.
This switches the auto makeup gain feature on and off.
When this is set to "ON, " the final output volume
level after applying the compressor is automatically
adjusted according to the "THRESHOLD" and "RATIO"
AUTO GAIN settings.
The total of the "MAKEUP GAIN" setting value
described below and the value calculated by auto
makeup gain becomes the final output volume level
(up to +34 dB).
This adjusts the final output volume level after
MAKEUP GAIN
applying the compressor.
MEMO
When the compressor is turned on, the COMP/LMT indicator
lights up while compression is applied to the input audio.
Equalizer (EQ)
This adjusts the sound quality for each frequency band.
Menu item Explanation
EQ Hi This boosts or attenuates the high band.
This adjusts the center frequency when changing the
EQ Hi FREQ
sound quality in the high band.
EQ Mid This boosts or attenuates the middle band.
This adjusts the center frequency when changing the
EQ Mid FREQ
sound quality in the middle band.
This adjusts the width of the frequency band when
EQ Mid Q
boosting or attenuating the middle band.
EQ Lo This boosts or attenuates the low band.
This adjusts the center frequency when changing
EQ Lo FREQ
the sound quality in the low band.