Video Operations; Switching The Video; Switching Using The A/B Fader - Roland v-1hd Owner's Manual

Video Operations

Switching the Video

You can switch the video input to bus A and to bus B of the video mixer.

Switching Using the A/B Fader

You operate the A/B fader to switch between two video feeds. The video on the bus toward which the A/B fader
is flipped is output (A/B mode).
1.
Use the [A-1] through [A-4] and [B-1] through
[B-4] buttons to select the video to input on bus
A and bus B.
Bus A
Bus B
Lighted in red:
Lighted in green: Video to be output next
Lighted in white: Channel with video input
2.
Press the [WIPE], [MIX], or [CUT] button to
select a transition effect.
The selected button lights up.
Button Explanation
The original video is broken into by the next
[WIPE]
video.
As the original picture gradually disappears, the
[MIX] next video is overlaid and progressively grows
more visible.
[CUT] The picture switches instantly.
MEMO
5 You can change the transition pattern used for a wipe
or mix transition. For details, refer to "Using a Different
Transition Pattern" (p. 19).
16
Video currently being output
3.
Move the A/B fader to the bus A position or the
bus B position.
The output video is switched
MEMO
5 You can change the color in which the [A-1] through
[A-4] and [B-1] through [B-4] buttons light up. Press and
hold the [(TAP) BPM] button g at the SETUP menu, use
"PGM LED" (buttons for current video output) or "PST
LED" (buttons for next video output) to make the setting.
5 Directly selecting the video channel at the bus position of
the video currently being output switches the video with
a cut, regardless of any selection of a transition effect.
About the Operation Mode for Video Transitions
Two operation modes are available for video
transitions made using the A/B fader: the "A/B
mode" and the "PGM/PST mode. "
To set the operation mode, press and hold the
[(TAP) BPM] button g use "A/B MODE" at the
SETUP menu.
A/B Mode
The video on the bus toward which the A/B fader is flipped
is output.
PGM/PST Mode
PGM Lighted in red:
Video currently being output
PST Lighted in green:
Video to be output next
The video at the PGM (bus A) position is always output,
and for PST (the bus B position), these select the video to
be output next.
Operating the A/B fader causes the selected video at the
PST (bus B) position to be output from the PGM (bus A)
position.
* Bus assignments made using EFFECTS [ON] buttons or
TRANSFORMER buttons (bus A or bus B) do not change.