Audio Operations; Adjusting The Volume Level - Roland V-1SDI Owner's Manual

Audio Operations

Adjusting the Volume Level

This adjusts the volume level of input audio and output audio.
1.
Display the AUDIO menu (p. 12), then select
the input audio whose volume level you want
to adjust.
You use the following menu items to adjust the
volume level of input audio.
AUDIO LEVEL (page 1/15)
Menu item
SDI 1–3 INPUT LEVEL
HDMI 3, 4 INPUT LEVEL
AUDIO INPUT LEVEL
MIC INPUT LEVEL
2.
Use the A/B fader to adjust the volume level for
the respective input audio.
Raise the volume level of audio you want to make
more prominent, such as a microphone, and
lower the volume level for other audio.
When no audio is input, and for audio that is
unused, set the volume level to "-INF. "
MEMO
5 Setting "MASTER OUTPUT LEVEL" to "-INF" results in no
audio output from the output connectors.
5 To adjust MIC input sensitivity, you use the [MIC] knob on
the side panel.
3.
Select "MASTER OUTPUT LEVEL."
26
Explanation
Input audio from respective SDI
IN sources
Input audio from respective
HDMI IN sources
Input audio from AUDIO IN
Input audio from MIC
4.
Use the A/B fader to adjust the volume level of
output audio.
5.
Quit the menu (p. 12).
MEMO
5 You can also use the [OUTPUT FADE] knob to adjust
the volume level of output audio. For details, refer to
"Functioning of the [OUTPUT FADE] Knob" (p. 21).
Center: MASTER OUTPUT LEVEL setting value
-INF
5 You can output a test tone, which is useful for adjusting
the volume level. Go to the SETUP menu, and at SYSTEM
(page 16/16), set "TEST TONE OUTPUT" to "-20 dB, " "-6 dB, "
or "0 dB. "
5 You can check the AUDIO indicator or the level meter
(p. 16) to determine whether the volume has been
adjusted to a suitable level.
AUDIO indicator
Indicator Status
This lights up at 0 dB or higher. It indicates
Red
an excessive volume level.
This lights up at -19 to -1 dB. It indicates an
Yellow
appropriate volume level.
This lights up at -50 to -20 dB. It indicates a
Green
too-low volume level.
* By factory default, the display of the AUDIO indicator is
set to "MASTER OUT" (output audio signal level).
If you want to use the AUDIO indicator to monitor other
audio signal, go to the SETUP menu, and at PANEL (page
8/15), make the setting using "AUDIO LED. "
* If the volume level of speaker output is unsuitable
even when the volume level on the V-1SDI has been
adjusted so that the AUDIO indicator and level meter
light up in yellow, adjust the volume for the speakers
and amplifiers. Using "MASTER OUTPUT LEVEL" to make
adjustments can sometimes result in distortion or
poorer sound quality.
-INF
Level meter
(dB)
Red
0
-6
Yellow
-10
-20
-30
Green
-40
-50