Table of Contents
Advertisement
12
Appliance Setup
A. Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Remove the glass assembly from the firebox by releasing
the two top glass latches and then the two bottom
glass latches. Hold glass in place with one hand and
disengage glass latches with the other hand. Remove
glass assembly from the appliance. See Figure 12.1.
Replacing Fixed Glass Assembly
• Place the glass assembly on the appliance. Latch the
two bottom glass assembly latches and then the two top
glass latches. Hold glass in place with one hand and
secure glass latches with the other hand. See Figure
12.1.
GLASS LATCHES
(BOTH TOP AND BOTTOM)
GLASS ASSEMBLY
Figure 12.1 Fixed Glass Assembly
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox. If an In-Wall kit has been purchased, a splatter
guard will be included. The splatter guard is a piece of
corrugated material used to protect the appliance dur-
ing the installation process before finishing work on the
whole hearth is complete. Splatter guards must be re-
moved before appliance is fired. See Section 11.E for
more information on installation of the splatter guard.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
58
Heatilator • ION-V7, ION-S7, ION-H7 Installation Manual • 2276-980 Rev. E • 5/15
Remove the glass shipping brackets by removing the two
screws on each bracket. Discard glass shipping brackets.
See Figure 12.2.
GLASS SHIPPING BRACKETS
(DISCARD)
Figure 12.2 Remove Shipping Brackets
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Decorative Fronts/Mesh
The decorative fronts designed for this appliance include
a mesh screen. Installation of the decorative front/mesh
screen assembly is required for operation of this appli-
ance. For installation instructions, see the instructions
included with the decorative front.
WARNING! Risk of Fire! Install ONLY doors or fronts
approved by Hearth & Home Technologies. Unapproved
doors or fronts could cause fireplace to overheat.
This fireplace has been supplied with an integral
barrier to prevent direct contact with the fixed glass
panel. DO NOT operate the fireplace with the barrier
removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
the decorative front.
Advertisement
Table of Contents
