Table of Contents
Advertisement
D. Install Appliance Into Outer Wrap (On-
Wall Installation)
1. Install the firebox into the outer wrap by mating the tabs
on the outer wrap with the notches located on the lower
left and right bottom corners of the firebox. Do not grab,
lift or carry the appliance by the top heat shield, or com-
ponent tray. See Figure 6.13. The process of mating the
tabs and notches accommodates the alignment of the
screws with the corresponding holes. The tabs on the
outer wrap should be bent outward as shown in Figure
6.13. Reinstall screws using Figure 6.8 as a reference.
DO NOT GRAB, LIFT, OR CARRY THE APPLIANCE BY THE
TOP HEAT SHIELD OR COMPONENT TRAY.
Figure 6.13 Install Firebox On Appliance Outer Wrap
NOTCH
TAB BENT
OUTWARD
Heatilator • ION-V7, ION-S7, ION-H7 Installation Manual • 2276-980 Rev. E • 5/15
TAB
LOCATION
TAB AND
NOTCH ENGAGED
35
Advertisement
Table of Contents
