Table of Contents
Advertisement
11
Appliance Setup
A. Remove the Packaging
Remove the shrink film, corrugated top cap, bottom cap
and column protectors from the appliance.
B. Remove the Shipping Materials
Remove the shipping materials from inside or under-
neath the firebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative front of the appliance,
depending on the fireplace model. Splatter guards
must be removed before appliance is fired.
• It is permissible to use metal tape to temporarily se-
cure the splatter guard in place.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
C. Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
•Pull the four (two upper and two lower) glass assembly
latches out of the groove on the glass frame. Refer
to Figure 11.1.
•Remove the glass assembly from the appliance.
Latches
(both bottom
and top)
Glass
Assembly
Figure 11.1
Glass Assembly
Remove Top Log Pack
The top log pack is shipped inside the firebox. When you
remove the glass, the log pack will come out also.
Heatilator • NNXT4236IF-B, NNXT4236ILF-B, NNXT3933IF-B, NNXT3933ILF-B Installation Manual • 2384-980 Rev. J • 6/17
D. Remove Packing Material
Remove the two pieces of foam packing material. See
Figure 11.2.
Figure 11.2
Remove Packing Material
E. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
51
Hide quick links:
Advertisement
Table of Contents
