In Wall - Finishing - Heatilator ION-V7 Installation Manual

E. In Wall - Finishing
The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. The splatter guard is shipped with the In-
Wall Kit on the ION models. Splatter guards must be
removed before appliance is fired.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
SPACE
Figure 11.15 Splatter Guard Installation
1. Install the splatter guard in the space between the tub
and the top and sides of the appliance outer wrap.
See Figure 11.15.
2. To gain access to the component tray, lift the flap on
the splatter guard and crease the perforation by hand.
Bend the tabs and insert them into the slots on the
splatter guard. See Figures 11.16 and 11.17.
Heatilator • ION-V7, ION-S7, ION-H7 Installation Manual • 2276-980 Rev. E • 5/15
CREASE LOCATION
Figure 11.16 Splatter Guard Installed
TABS INSERTED INTO SLOTS
COMPONENT
TRAY ACCESS
PANEL
Figure 11.17 Component Tray Access
SLOTS
57