Table of Contents
Advertisement
11
In-Wall Installation
The ION may be installed recessed into the wall using the
In-Wall Tub.
A. Wall and Appliance Preparation
WARNING! Risk of Fire! Comply with all minimum clear-
ances as specified. Framing closer than the minimums listed
must be constructed entirely of noncombustible materials
(i.e., steel studs, concrete board, etc.)
1. Prepare 2 in. x 6 in. framing as shown in Figure 11.1.
Note: 2 X 4 framing is not recommended in geographical
regions that require an R-19 insulation value.
FRAMING
A
DIMENSIONS
ION-V7
20-1/8 in.
ION-S7
29-3/8 in.
ION-H7
39-3/8 in.
FINISHED
FLOOR
C=4 IN. MIN.
Figure 11.1 Framing Dimensions and In-Wall Tub - Clearances
50
B
C
43-1/8 in.
4 in. min.
40-1/2 in.
4 in. min.
39 in.
4 in. min.
WALL - FRAMED
A
B
Heatilator • ION-V7, ION-S7, ION-H7 Installation Manual • 2276-980 Rev. E • 5/15
2. A Corrugated Template may be used to simplify the
installation process. Contact your dealer or see Ser-
vice Parts section in Owner's manual to order. Using
the template for installations of the ION will help when
locating the gas and electrical connections for the ap-
pliance. Install the corrugated template as shown in
Figure 11.2. Use blocks to position the corrugated
template in regards to depth.
3. Bring electrical and gas hookups to location designat-
ed by markings on corrugated template. Remove tem-
plate and blocks when utility installation is complete.
Note: Hard-piped gas connections must be terminated
with a specific "Z" dimension depth. See references to "Z"
dimension in Figure 11.2. Terminating the Hard-piped gas
connection with the proper "Z" dimension will simplify the
process of connecting the gas to the appliance.
IN-WALL TUB CLEARANCES
OPTIONAL
SEE DIMENSION A
FINISHING
FOR CLEARANCE
STRIPS
(SIDE)
SEE DIMENSION B
FOR CLEARANCE
(TOP)
ZERO
CLEARANCE
(BACK)
ZERO
CLEARANCE
(BOTTOM)
Advertisement
Table of Contents
