Table of Contents
Advertisement
B. Install Appliance Corrugated Template
(On-Wall Installation)
For new construction installations in which the ION will
be mounted flush on the wall, the following preparations
must be made. A Corrugated Template may be used to
simplify the installation process. Contact your dealer or
see Service Parts section in Owner's manual to order.
Using the template for new construction installations of
the ION will help when locating the gas and electrical con-
nections for the appliance. Template layout dimensions
for each specific model are provided in Figures 6.5, 6.6,
and 6.7.
1. Detemine the location of the appliance.
2. Hang corrugated template on studs using a permanent
method such as nails, staples, tacks or screws.
3. Bring electrical and gas hookups to locations desig-
nated by markings on corrugated template.
Note: Hard-piped gas connections must be terminated
with a specific "Z" dimension depth. See references to "Z"
dimension in Figure 6.3. Terminating the Hard-piped gas
connection with the proper "Z" dimension will simplify the
process of connecting the gas to the appliance.
WARNING! Risk of overheating! Install appliance a
minimum of 4 inches off of finished floor.
• Convection air flow could be compromised and cause
overheating.
• Decorative fronts will not fit properly.
VENT
GLASS VIEWING AREA
GAS ACCESS
LOCATION
Figure 6.4 Corrugated Template Layout
30
ELECTRICAL
ACCESS LOCATION
Heatilator • ION-V7, ION-S7, ION-H7 Installation Manual • 2276-980 Rev. E • 5/15
STUD WALL TOP VIEW
2 X 6 STUD
GAS CONNECTION
MOUNT CORRUGATED TEMPLATE
Z = 1-3 IN.
ON THIS SURFACE
GAS ACCESS
Figure 6.3 Hard-Piped Gas Line Termination and Electrical Service
= VENT ACCESS
= GLASS VIEWING AREA
= GAS & ELECTRICAL ACCESS
4 IN. MINUMUM TO FINISHED FLOOR
WALL
ELECTRICAL ACCESS
Advertisement
Table of Contents
