Table of Contents
Advertisement
11 11
Appliance Setup
A. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
•
The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative barrier front of the ap-
pliance, depending on the fireplace model. Splatter
guards must be removed before appliance is fired.
•
The left and right side non-combustible boards are
packaged within the splatter guard. Remove them
by carefully disengaging the tabs from the slots on
the lower portion of the splatter guard. Install as
instructed in Section 6.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
C. Install the Glass Refractory (Optional)
An optional glass refractory kit is available for use with
the RAVE32-IFT-B, RAVE36-IFT-B and RAVE42-IFT-B
models. Install the glass refractory per instructions included
with the kit.
D. Install LED Lights (Optional)
An optional LED light kit is available for use with the RAVE42-
IFT-B, RAVE36-IFT-B and RAVE32-IFT-B models. Install
the LED lights per the instructions included in the kit.
E. Install Stones (Optional)
An optional stones kit is available for use with the RAVE42-
IFT-B, RAVE36-IFT-B and RAVE32-IFT-B models. Install
the stones per instructions included with the kit.
Heatilator • RAVE32-IFT-B, RAVE36-IFT-B, RAVE42-IFT-B Installation Manual • 2619-983 Rev. U • 9/22
68
F. Install Media Kit (Optional)
An optional decorative glass media kit is available for use
with the RAVE32-IFT-B, RAVE36-IFT-B and RAVE42-IFT-
B and models. Install the media per instructions included
with the kit.
Advertisement
Table of Contents
