Advertisement
<Caution>
•
Never turn the output selector switch while welding. Operation of this switch during welding can
cause damage to the switch.
This equipment allows two operators to weld simultaneously with minimal affect on each other.
Each operator can individually adjust their own welding current.
CV/CC SELECTOR SWITCH
OUTPUT TERMINAL A
(1) Stick Welding
1. Turn the CV/CC selector switch to CC.
2. Turn the output selector switch to Eco, Single or Dual, according to the desired mode of
operation.
3. Adjust welding amperage using the current adjust dial for the side being used (A or B). The
following table gives the approximate amperage for the corresponding position on the current
adjust dial.
1 Person
2 Persons
These values are approximations only. Factors such as the length of the welding cables and the
ambient temperature will affect the actual value.
When the remote control is used, these values may also vary.
CURRENT ADJ. DIAL B
CURRENT ADJ. DIAL A
Position
MIN
Eco
40
Single Use
110
Dual Use
55
ECO/SINGLE/DUAL
SELECTOR SWITCH
OUTPUT TERMINAL B
Welding Current at the dial position
1
2
3
60
100
140
140
200
260
70
110
140
21
4
5
MAX
180
210
220
320
380
400
170
200
210
Advertisement
