Frequency Selector; Transporting - Shindaiwa DGW500M Owner's And Operator's Manual

<Note>
• The oil pressure monitor cannot detect oil deterioration. Change the engine oil
periodically. (Refer to section "12. (1) Changing the Engine Oil".)
• The charge monitor cannot detect battery deterioration or insufficient battery fluid.
Inspect the battery fluid level periodically. (Refer to section "7-5. Battery Inspection".)
• Inspect the fuses if the engine is automatically stopped and none of the monitor
lamps ("WATER TEMP", "CHARGE" and "OIL PRESS") light up. (Refer to
section "4. Part Names" for fuse location.)
If a fuse has blown, it is probable that there is a fault in an electric part or the wiring.
Request repair at the retail outlet where the equipment was purchased.
(4) Overheat Monitor Lamp
The overheating monitor lamp ("OVERHEAT") flash and the equipment cuts the
output if the equipment is used excessively over the duty cycle or output. Then it is
probable that overloading is the cause. Use within the rated duty cycle or output.
(Refer to section "14．Troubleshooting" for Error Code Display.)
<Note>
• There may be a case that the lamp will not flash, depending on the weather
condition.

5-4. Frequency Selector

Warning: Injury/Electric Shock
• Do not operate the equipment with any doors or covers open. There is a danger
of hair, body parts and other items being caught up in moving parts such as
cooling fans and belts.
Caution: Burn
• The engine, muffler and similar parts are extremely hot during operation and
immediately after stopping the equipment. Never touch hot parts.
Caution: Physical and Secondary Damage
• Set the frequency in accordance with the devices using the equipment.
This equipment can operate at
either 50Hz or 60Hz.
Set the frequency selector located
inside the side door to change the
frequency in accordance with the
devices using the equipment.

6. Transporting

Warning: Injury
• The lifting lug is designed to be used only for lifting the equipment. Do not lift the
equipment with any heavy items (such as a trailer, gas canister and additional
fuel tank) added to the equipment.
• When lifting the equipment, always use a lifting lug. Do not lift the roping lug, for
it may cause equipment to drop due to roping lug breaking off.
- 11 -
Frequency
Selector
(Inside)