Advertisement
7. Equipment
7-1 Eco Welding
This equipment incorporates the Eco welding feature that allows welding operations at a reduced
speed (2100 rpm) which results in lower noise levels, reduced fuel consumption and lower emission
levels than with conventional welders.
With the selector switch in the Eco position, welding can be done with up to 3/16" (5.0 mm) welding
rod even though the engine is turning at a reduced speed.
<Caution>
•
Do not turn the output selector switch while welding.
•
The Eco feature is available for welding only. In the Eco mode the generator output is not
available.
7-2. CV/CC
Side A of this welder can be a Constant Voltage Power Source. By connecting a wire feeder to side A,
and then turning the CC/CV Selector Switch to CV, you have the ability to perform semi-automatic
welding such as MIG, MAG, SS, etc.
When the CC/CV selector switch is positioned to CV, Side A terminals become a Constant Voltage
Power Source. In this position voltage is adjusted with the voltage adjust dial A.
When the CC/CV selector switch is positioned to CC, Side A terminals become a Constant Current
Power Source. In this position current is adjusted with the current adjust dial A.
<Caution>
•
Do not turn the output selector switch while welding.
•
Side B Output Terminals can be used only as a Constant Current Power Source.
7-3. Remote Control (Optional)
Remote control operation using the Side A Terminals is available by plugging a remote control into
the receptacle on the lower right side of the control panel. This will allow you to adjust either welding
voltage or welding current from the Side A Terminals up to 295 feet away from the welder when using
an optional extension cord.
Remote Control Connection
REMOTE CONTROL
7
Advertisement
