Advertisement
<Caution>
•
Do not plug the remote control box into any energized AC receptacle.
•
Do not connect other loads to the circuit that is powering the remote control.
7-4. Meters
This equipment features reliable digital meters for welding voltage and current and alternator three
phase output voltage and frequency
DC Volt Meter and Ampere Meter for welding Side A and Side B.
•
When the output selector switch is positioned at [Eco] or [Single], the Side B meters are
inoperative.
3-Phase Volt Meter
•
This meter displays the 3-Phase output voltage of the AC generator.
Frequency Meter
•
This meter displays the AC generator output frequency in Hertz.
7-5. Monitor Lamps
This equipment has monitoring lamp indication for WATER TEMPERATURE, BATTERY CHARGING,
OIL PRESSURE, PREHEAT, AND OVERHEAT.
Water Temperature
Battery Charge
When the starter switch is placed in the RUN position, the monitoring lamps indicating BATTERY
CHARGING, OIL PRESSURE and OVERHEAT will turn ON. Once the engine starts, if there are no
abnormalities in the parameters these circuits monitor, the lamps will turn OFF. If an abnormality is
detected on any of the circuits monitored, other than OVERHEAT, the corresponding monitor lamp will
flash, and the engine will automatically shut down. An OVERHEAT abnormality will cause the lamp to
flash and the output of the welder to be decreased.
If there is an automatic shutdown, turn the starter switch to the STOP position. Investigate the cause
of and correct the reason for the shutdown prior to trying to restart the engine.
Oil Pressure
Overheat
Preheat
8
Advertisement
