Download Print this page

Shindaiwa DGW400DM-C Owner's Manual page 28

Sound attenuated diesel engine powered welder/generator
Hide thumbs Also See for DGW400DM-C:

Advertisement

1. Oil Change
Frequency
First Time
nd
2
Time and
thereafter
Procedure
1. Remove the oil fill cap.
2. Remove the oil drain plug.
<Caution>
Oil will begin to drain as soon as the oil drain plug is loosened. Ensure there is adequate means
to contain the used oil that is being drained.
3. Once the oil is completely drained, reinstall the oil drain plug.
4. Fill the oil to the max level as measured by the dipstick (approximately 4.7 quarts).
5. Reinstall the oil fill cap hand tight.
<Caution>
Refer to Section 6-1 Checking Engine Oil for the proper weight oil to use.
Change the packing, whenever changing oil.
Part No. 6C090-58961 (Kubota part no.)
2. Oil Filter Change
Frequency
First Time
nd
2
Time and
Thereafter
Procedure
1. Completely drain the engine oil.
2. Loosen and remove the oil filter.
3. Dampen the new oil filter gasket with clean engine oil.
4. Screw the new filter (Kubota part no. 16271-32090) into place and tighten it by hand until the
gasket contacts the seat. Give it an additional 1 1/4 Turns to seat the new filter, using an oil filter
wrench.
5. Fill the oil to the max level as measured with the dipstick.
Side Door
50 hours
Every 100 hours
50 hours
Every 200 hours
Oil Filter
Dipstick
27
Oil Fill
Oil Drain Plug
Gasket

Advertisement

loading