Panasonic CS-VE9NKE Service Manual page 99

6 Disconnect the connectors and terminals.

Connectors
CN-TH2 (green) ･････ Indoor intake air temperature sensor No. 1
o
CN-DISP (white) ･････ Control board (human sensor unit, signal receptor and indicator) No. 2
o
CN-FM (white) ･････ Fan motor No. 3
o
CN-TH1 (yellow) ･････ Indoor heat exchanger temperature sensor No. 4
o
CN-STM1 (green) ･････ Vertical louver motor (lower) No. 6
o
CN-STM2 (white) ･････ Vertical louver motor (upper) No. 7
o
CN-STM3 (blue) ･････ Horizontal louver motor (right) No. 8
o
CN-STM4 (blue) ･････ Human sensor drive motor No. 9
o
CN-STM5 (black) ･････ Ventilation/Exhaust switching motor No. 0
o
CN-STM6 (gray) ･････ Front panel motor No. !
o
CN-STM7 (red) ･････ Horizontal louver motor (left) No. @
o
CN-SWSEN (white) ･････ Control board (emergency operation button, front panel switch) No. $ ※
o
CN-NANO (white) ･････ Highvoltage power supply (nanoe) No. ¥
o

Note on disassembly: There is no need to disconnect the connector marked with ※ to remove the
control board box. (However, when removing the control board, the connector marked with ※ should
be disconnected.)

Tab terminals
CN-TAB1 (white) ･････ Power supply No. (
o
CN-TAB2 (white) ･････ Power supply No. )
o
7 Remove the screw (1 piece) of the clamp for the power cord and then remove the clamp.
99