Panasonic CS-VE9NKE Service Manual page 122

16.2.8.5 Replacement of Heat Charger
Exchange with the new heat charger.
16.2.8.6 Stick Heat Transferring Sheet and Fix the Heat Charger on the Compressor by
Band
1 Peel-off the yellow film from new heat transferring sheet, and stick it on compressor body. Then peel off
transparent film for attaching heat charger. For sticking/adhering the heat transferring sheet, the datum
shown in figure on right. (in a vertical direction, longer side up)
2 When installing heat charger on compressor, make sure the three parts of compressor legs and heat charger
legs are engaged.
3 Install heat charge storage fixing bracket to the original position and firmly fix compressor and heat charger
with 2 resin bands (large).
Caution
1. Carefully read the instructions before proceeding to the replacement of heat transferring sheet.
2. When tightening resin bands, use pliers to fully pull in bands and make sure there is no cracking or
loosening. Cut off the end of band using nippers.
122