Panasonic CS-VE9NKE Service Manual page 120

5 Cut off the band (small) for holding soundproof board and heat charger.
6 Remove 4 screws (see figure) and slide soundproof board towards to propeller fan side to remove.
7 Remove soundproof material at upper compressor.
8 Remove discharge pipe sensor.
9 Remove terminal cover from the compressor.
10 Remove 3 lead wires from compressor terminal.
11 Make sure remaining particular plate at the lower compressor terminal are removed.
12 Release Velcro on front of soundproof material and remove mounting nuts (left & right) for compressor by the
wrench.
120