Panasonic CS-VE9NKE Service Manual page 124

16.2.9 Heat Charger Sensor Replacement Procedure
1 Disconnect the sensor connectors from control board. (CN-TH2: red)
2 Open Velcro on soundproof material to expose the sensor.
3 Insert flat screwdriver into heat charger fixing bracket to open it wide enough to remove the sensor.
(approximately 7mm)
Do not open the bracket too wide.
4 Remove polyethylene sheet to expose the heat charger sensor.
5 Replace with a new heat charger sensor, and fix it tightly with adhesive polyethylene sheet at its original
position.
124