Exiting The Energy Saver Mode - Fuji Xerox ApeosPort-IV C5575 User Manual

2 Product Overview

Exiting the Energy Saver Mode

The following describes how to exit the Energy Saver mode.
The Energy Saver mode is exited in the following instances:
The machine exits the Energy Saver mode partially depending on the settings. For more information, refer to "5. Tools" >
"Common Service Settings" > "Energy Saver Settings" > "Energy Saver Control" in the Administrator Guide.
Pressing the <Energy Saver> button
Receiving a job
Selecting [Apply] in CentreWare Internet Services
Setting a document in the document feeder
Opening the document cover
Detecting human presence by the human motion sensor of the machine
Important • The machine may not immediately exit the Energy Saver mode if the machine enters the mode by
2
When the following device is connected to the machine and a user performs the following
operation, the Lower Power mode can be deactivated without pressing the <Energy Saver>
button.
Touch the card to IC Card Reader (optional)
Note
1
Press the <Energy Saver> button.
60
pressing the <Energy Saver> button and press the button again in five seconds to exit.
• If the machine is in the Sleep mode, however, the Sleep mode will not be deactivated by the
operation above. Set the time long to elapse until the machine enters the Sleep mode. For more
information on how to change the time to elapse until the machine enters the Sleep mode, refer to
"1 Before Using the Machine" > "Energy Saver Mode" > "Changing the Interval for Entering Energy
Saver Mode" in the Administrator Guide.
<Energy Saver> button