Toshiba e-STUDIO230L Service Handbook page 738

[B] Data cloning procedure (Restore)
Important:
• The file system for the USB storage device should be in the FAT format. Note that any device
formatted in FAT32 or NTFS will not be operated. Its file system can be confirmed by opening
the properties of the device from Windows Explorer.
• Never turn the power of the equipment OFF during data cloning, or the data could be dam-
aged and the operation not carried out properly.
(1) Shut down the equipment.
(2) Connect the USB storage device to the USB connector (host) on the SYS board.
Notes:
• Do not connect multiple USB storage devices together.
• The USB storage device can be connected to either of 2 USB connectors (host).
• In case the printer kit (GM-1070/1071/1080U/1081U), printer/scanner kit (GM-2070/2071/
2080U/2081U) and scanner kit (GM-4070 or GM-4080U) are used, the data must be restored
after all the "dongles" are disconnected from the USB connector (host) and only the USB stor-
age device is connected.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
DATA CLONING with USB STORAGE DEVICE (e-STUDIO202L/203L/232/233/282/283)
USB storage device
Fig. 9-18
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
9 - 12
05/11
USB connector
( host )