Toshiba e-STUDIO230L Service Handbook page 21

Notes:
1. The bridge kit (KN-3520) is necessary for installation of the finisher (MJ-1022 or MJ-1025).
2. The saddle stitch finisher (MJ-1025) is necessary for installation of the hole punch unit
(MJ-6005N/E/F/S).
3. The PCI slot (GO-1060) is necessary for installation of the scrambler board (GP-1040).
4. The antenna (GN-3010) is necessary to enable the wireless LAN module (GN-1041) and
Bluetooth module (GN-2010).
5. When the wireless LAN module (GN-1041) and the Bluetooth module (GN-2010) are
installed, only 1 antenna (GN-3010) can be connected to each.
6. GM-1080U / GM-2080U / GM-4080U are exclusive to e-STUDIO202L. They do not operate
with e-STUDIO232/232S/282/282S.
7. GM-1081U / GM-2081U / GM-4080U are exclusive to e-STUDIO202L/203L. They do not
operate with e-STUDIO232/232S/233/282/282S/283.
8. The Printer kit (GM-1070/1080U) or Printer/Scanner kit (MG-2070/2080U) does not have a
function for printing an XPS file.
9. To enable an XPS file to be printed by the Printer kit (GM-1071/1081U) or Printer/Scanner kit
(GM-2071/1081U), the Memory (GC-1230) is required to be installed.
10.To enable an XPS file to be printed by the Printer ELK (GM-1130/1140U) or Printer/Scanner
ELK (GM-2130/2140U), the Memory (GC-1230) is required to be installed.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1 - 9
07/11
1