Toshiba e-STUDIO230L Service Handbook page 609

PWA-DWNLD-350-JIG2 (48MB)
Important:
The download jig (PWA-DWNLD-350-JIG) is the jig in which the Flash ROM is mounted on the
board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the data to
these Flash ROMs. Refer to the following to write the data.
P.6-48 "6.2.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
K-PWA-DLM-320
Important:
Pay attention to the direction of the ROM.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Connector
( for SYS board
connection )
ROM4
ROM5
ROM6
Fig. 6-34 Jig board: PWA-DWNLD-350-JIG2 (48 MB)
Connector Mark for ROM
installation direction
Fig. 6-35 Jig board: K-PWA-DLM-320
6 - 33
05/11
Connector
( for ROM writer
adapter connection )
ROM1
ROM2
ROM3
LED
ROM
e-STUDIO200L/202L/203L/230/232/233/280/282/283
FIRMWARE UPDATING
6