Toshiba e-STUDIO230L Service Handbook page 494

[EA60] Early arrival jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment?
YES
NO
Is the connector J10 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (S2) open cir-
cuited?
YES
NO
Is the inlet sensor working properly? (Check the movement of the actuator.)
l NO
l
YES
Replace the finisher controller PC board.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
Remove the paper.
Connect the connector securely. Replace the harness.
1) Connect the connector of the inlet sensor securely.
2) Attach the actuator securely if its shaft is out of place.
3) Replace the inlet sensor.
5 - 42
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved