Toshiba e-STUDIO230L Service Handbook page 688

The followings are two output channels which are linked with the door switch.
1) +5.1V
+5.1VD : CN706
Output to the LGC board
2) +24V
+24VD1 : CN706
Output to the LGC board, PFP/LCF (via LGC board)
+24VD1 : CN707
Output to the main motor
+24VD2 : CN706
Output to the LGC board, High-voltage transformer (via LGC board),
Bridge unit / Job separator / Offset tray (via LGC board)
+24VD2 : CN707
Output to the ADU board
+24VD3 : CN708
Output to the RADF
+24VD4 : CN708
Output to the SLG board
+24VD5 : CN707
Output to the finisher
<<Output connector>>
Not linked with the door switch
Connector
CN705 For the SYS board
CN706 For the LGC board, FUS board, PFP/LCF (via LGC
board), Bridge unit / Job separator / Offset tray (via
LGC board)
CN707 For the finisher
CN708 For the SLG board, RADF
Linked with the door switch
Connector
CN706 For the LGC board, High-voltage transformer (via
LGC board), PFP/LCF (via LGC board), Bridge unit /
Job separator / Offset tray (via LGC board)
CN707 For the ADU board, finisher
CN708 For the SLG board, RADF
e-STUDIO200L/202L/203L/230/232/233/280/282/283
POWER SUPPLY UNIT
Pin 2
Pins 11, 12, 13 and 14
Pins 15 and 16
Pins 5 and 6
Pins 11 and 12
Pins 23 and 24
Pins 19 and 20
Pin 8
Destination
Destination
7 - 2
+3.3VA, +3.3VB, +5.1VA, +5.1VB,
+12VA, +12VB, -12VA, -12VB
+3.3VB, +5.1VB, +12VB
+5.1VB
+3.3VB, +5.1VB, +12VB
+5.1VD, +24VD1, +24VD2
+24VD1, +24VD2, +24VD5
+24VD3, +24VD4
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Voltage
Voltage