Toshiba e-STUDIO230L Service Handbook page 560

15)Poor image transfer
Defective area
Paper
Transfer charger
Registration roller
High-voltage transformer
(Transfer charger)
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
Fig. 5-15
Step Check items
1 Is the paper in the drawer or LCF/
PFP curled?
2 Is the paper in the drawer or LCF
damp?
3 Is the paper type corresponding to its
mode?
4 Using the recommended paper?
5 Is the transfer charger case dirty?
6 Is the transfer charger wire dirty?
7 Is there any abnormality related to
the registration roller or with the roller
itself?
8 Is the high-voltage transformer out-
put defective?
5 - 108
Prescription
Reinsert the paper with the reverse
side up or change the paper.
Avoid storing paper in damp place.
Select the proper mode.
Use the recommended paper.
Clean the transfer charger case.
Clean the transfer charger wire.
Clean the roller if it is dirty. Securely
attach the springs if they are
detached. Replace the clutch if it is
defective. Adjust the rotation speed
of the roller.
Adjust the output, or replace the
transformer.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved