Toshiba e-STUDIO230L Service Handbook page 328

[E] Primary scanning data laser writing start position at duplexing
Note: Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[E-1] Adjustment for long-sized paper
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [3] [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from standard
drawer of the equipment (Refer to *).
* Perform 08-477 and check the value.
If the value is 0, use the lower drawer.
If the value is 1, use the upper drawer.
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
[ENTER] or [INTERRUPT] (Stored in memory)
"100% A" is displayed.
Press [3] [FAX]
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.05 mm/
step).
[E-2] Adjustment for short-sized paper
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [3] [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper
drawer.)
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
[ENTER] or [INTERRUPT] (Stored in memory).
"100% A" is displayed
Press [3] [FAX]
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.05 mm/
step).
e-STUDIO200L/202L/203L/230/232/233/280/282/283
ADJUSTMENT
(Key in code [498]) [START]
(A grid pattern is printed out.)
(Key in the code [498])
(A grid pattern is printed out.)
3 - 10
04/09
(Adjustment Mode)
[0] [START]
(Adjustment Mode)
[START] [1] [START]
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved