Toshiba e-STUDIO230L Service Handbook page 498

[ 5 ] Other paper jam
[EAD0] Print end command time-out jam
Is the main motor rotating normally?
NO
1) Replace the SYS board.
2) Replace the LGC board.
[EAE0] Receiving time time-out jam
Is the finisher working?
YES
NO
1) Check if the voltage (24V) is being supplied to the finisher.
2) Check the connection of the LGC board and IPC board.
3) Check if the harness connecting the IPC board and finisher I/F connector of the equip-
ment side is open circuited.
4) Check if the harness connecting the I/F connector of the finisher side and finisher con-
troller PC board is open circuited.
5) Replace the finisher controller PC board.
[EB30] Ready time time-out jam
Is there paper in the equipment?
NO
YES
Are the IPC board and LGC board properly connected to each other?
NO
YES
Is the harness securely connected to the IPC board?
NO
YES
Is any of the connector pins of the harness connecting the equipment and finisher discon-
nected or any of those harnesses open circuited?
NO
YES
1) Replace the IPC board.
2) Replace the LGC board.
3) Replace the finisher controller PC board.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
Replace the finisher controller PC board.
Replace the LGC board.
Connect them properly.
Connect the harness properly.
Connect the pin or replace the harness.
5 - 46
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved